How long does it take to charge the e port controller?

How long does it take to charge the e port controller?

How long does it take to charge the e port controller?

 We like to allow 6-8 hours for a full charge, the LED light will not stay on and will turn off around 30 seconds after connect then turn back on when trickle charging

 

New E-Port Controller and LED Diagnostics

New E-Port Controller and LED Diagnostics

Feature Description
Advanced Battery Technology The new Lithium-Ion battery technology allows the E-Port controller to be 30% smaller than the old Control 10 while offering a larger power capacity.
Included Components Each Roller Shutter is supplied with the E-Port controller, wall plate, and charger.
Compact and Stylish The new controls are more compact and stylish compared to the old ODS Controller.
Model Applicability Applies to: 15.600.001 18650 E-Port Controller and 15.601.001 18650 E-Port RF Controller.
Controller Replacement The new E-Port controller will replace all previous models, fitting the existing wall plate and using the same charger.
LED Diagnostics
  1. Controller Response: If the controller is not responding, it may be in sleep mode. Plug in the charger to wake it up.
  2. CHARGE LED Flash: Indicates the controller needs charging. A full charge takes about 8 hours.
  3. TOP LED Flash: Indicates the controller is trying to drive a motor. Fit the controller to a wall plate and operate a motor.
  4. TOP LED On Continuously: Indicates the controller is in TEST mode. To exit, press UP, DOWN, STOP, STOP in sequence.
  5. Both LEDs Flashing: Indicates ERROR MODE. Remove the controller from any charging source and call for service.
RF Option The E-Port is also available with an RF option.
Battery Capacity The E-Port controller has a large battery capacity of 1,600mAh, despite being 30% smaller than the old Control 10.
Back to blog